jwestercamp Posted September 29, 2011 Report Share Posted September 29, 2011 anyone know if you need a special tool to change the pulley for a whipple? I hate to just use a gear puller on it haven't done it yet, but would like to know before i dive in. If there is a puller does anyone have one i can borrow, or know a good place to buy one? Thank you! Link to comment Share on other sites More sharing options...
blkGT500nCA Posted September 29, 2011 Report Share Posted September 29, 2011 I "think" whipple pulleys just unbolt and slide off after the belt tension is remove. Someone will confirm shortly I'm sure. Link to comment Share on other sites More sharing options...
jwestercamp Posted September 29, 2011 Author Report Share Posted September 29, 2011 That would bebawsome I hope so Link to comment Share on other sites More sharing options...
jmn444 Posted September 29, 2011 Report Share Posted September 29, 2011 Yes, no puller needed! Just unscrew the bolts (i break them loose with the belt still on THEN remove the belt), then it slides off easily. Put the new one on, snug up as best you can, then put the belt back on and torque them. 135 inch/lbs per Mike at whipple. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.