2BIGFRED Posted December 12, 2010 Report Share Posted December 12, 2010 I suck at stuff like this can someone throw up some quick instructions on this? Maybe to make things easier.. Link to comment Share on other sites More sharing options...
2007_Shelby_GT Posted December 12, 2010 Report Share Posted December 12, 2010 If your talking about the PIAA lights down low, next to the brake duct, it's a simple job. (I replaced one of the lenses that was cracked by a low-flying rock!) There are two screws on the housing that hold the front lens on, one on each side. LOOSEN, but DO NOT REMOVE the screws, then gently pull the lens away from the body of the light. Careful with the O-ring! You then have easy access to the bulb. Switch bulbs, (wear gloves as finger oil/moisture can cause the bulb to break/burn out), then reinstall the lens in the reverse order. Sam Link to comment Share on other sites More sharing options...
2BIGFRED Posted December 12, 2010 Author Report Share Posted December 12, 2010 ^^^^^ Thanks so much I will get it done my next day off Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.