Jump to content
TEAM SHELBY FORUM

Dyno Results


Mustang_racer

Recommended Posts

I went to Johnson MotorSports (JmsChip.com) and had them run a baseline run, then install cold air/pulley and canned tune and re dyno the car.

 

Temp was 94 degrees with 39% humidity.

 

Stock: 420 rwhp and 395 tq

 

Stage 2: 524 rwhp 516 tq

 

Runs done on same day within an hour of each other and on the same dynojet dyno.

 

 

http://forums.redlined.org/garage.php?mode...mp;image_id=503

Link to comment
Share on other sites

I went to Johnson MotorSports (JmsChip.com) and had them run a baseline run, then install cold air/pulley and canned tune and re dyno the car.

 

Temp was 94 degrees with 39% humidity.

 

Stock: 420 rwhp and 395 tq

 

Stage 2: 524 rwhp 516 tq

 

Runs done on same day within an hour of each other and on the same dynojet dyno.

http://forums.redlined.org/garage.php?mode...mp;image_id=503

 

Now that's more like it!! How high was the grin gain? :happy feet:

Link to comment
Share on other sites

Congratulations !

 

Very good numbers considering the heat ... your numbers are right where they should be.

 

How was your A/F ratio with stage II ?

Link to comment
Share on other sites

Congratulations !

 

Very good numbers considering the heat ... your numbers are right where they should be.

 

How was your A/F ratio with stage II ?

 

I asked my tuner about the a/f and he has it at about 11.9 a/f. he said it was a little high at low rpms and had to really dump some fuel in to avoid tip-in ping. This is my 5th mustang that he has tuned for me so i trust him. He said i was at 18.5 degrees of timing also. What a/f ratio is being used by other tuners?

Link to comment
Share on other sites

  • 6 months later...

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...
...