ITHERTZ66 Posted August 5, 2013 Report Share Posted August 5, 2013 I want to replace what appears to be cheap worm drive clamps that connect/secure the intake tube to the throttle body. The installer left the bolt/tightening portion on TOP of the tube rather than the side and it's rubbing on the hood. I would like to start over with NEW clamps. Any suggestions on what to use and where to obtain them? Thanks, Troy Link to comment Share on other sites More sharing options...
Jer Posted August 5, 2013 Report Share Posted August 5, 2013 That type of clamp is flexible enough to seal the diameter, as opposed to a "T-bar" type that expects a round mating surface. Just go with USA-made clamps (Ideal comes to mind), and that will do the job well. Jer Link to comment Share on other sites More sharing options...
Halsey Posted August 9, 2013 Report Share Posted August 9, 2013 316 Stainless Steel Smooth-Band Worm-Drive Hose/Tube Clamp Ideal, 1/2" Band Width Available from McMaster Carr P/N like 45945k19 Link to comment Share on other sites More sharing options...
ITHERTZ66 Posted August 10, 2013 Author Report Share Posted August 10, 2013 Thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.