FordRocks1 Posted July 8, 2013 Report Share Posted July 8, 2013 I've looked all around the net but no luck, anyone know how to take the headlight switch panel out. The light behind is out and I wanted to replace it but didn't want to break anything. Thanks. Link to comment Share on other sites More sharing options...
2007_Shelby_GT Posted July 9, 2013 Report Share Posted July 9, 2013 If I remember correctly, it just pops out, (the entire square area that includes both headlight and dimmer switch). Then I believe you can replace bulb from behind the panel. If I can find my instructions for the Shelby gauge pod I'll verify that. Sam Link to comment Share on other sites More sharing options...
2007_Shelby_GT Posted July 9, 2013 Report Share Posted July 9, 2013 See page 4: http://info.shelbyamerican.com/Instructions/gauge_pod.pdf Sam Link to comment Share on other sites More sharing options...
Jer Posted July 9, 2013 Report Share Posted July 9, 2013 Page 5. It pops right out with a gentle pry. Jer Link to comment Share on other sites More sharing options...
twobjshelbys Posted July 9, 2013 Report Share Posted July 9, 2013 Page 5. It pops right out with a gentle pry. Jer I would suggest masking the area above the insert with blue painters tape before making contact with the pry tool. The textured surface can show marring if you come in contact with a hard tool. Link to comment Share on other sites More sharing options...
2007_Shelby_GT Posted July 9, 2013 Report Share Posted July 9, 2013 Page 5. It pops right out with a gentle pry. Jer "Two twenty, two twenty-one, whatever it takes." Sam Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.