Jump to content
TEAM SHELBY FORUM

Oil Filter Relocation


Recommended Posts

Just installed S&H Performances Oil Filter relocation kit behind the drivers side bumper (no need to remove fender well plastic liner)

 

Using FRPP oil filter # M6731FL1A (3/4-16 threads)

 

Also be very careful about going from the Out on the engine block to the IN on the filter and the Out on the filter to the IN on the engine block (Easy to mix up).

 

Also upgraded the tiny screws (supplied) to 1/4 self tapping screws with a hex head

 

MADE IN THE USA ! ! ! !

 

CA_12221211233658-L.jpg

 

CA_12221210520896-L.jpg

 

 

CA_03151317422190-L.jpg

 

CA_03151317414896-L.jpg

 

CA_03151317413648-L.jpg

 

CA_03151317412528-L.jpg

Link to comment
Share on other sites

Andy, any special reason you decided to do this? I did notice that you were able to go to the larger FL-1A filter. I think Ford used to make same/similar kit. Not sure if they still offer or not.

 

 

Easier access to the filter and figured an extra 1/2 - 3/4 quart could not hurt.

 

Plus I had an extra $175 in my PayPal account !

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...
...