Jump to content
TEAM SHELBY FORUM

2873 Dyno'd again


Recommended Posts

Had a chance to get the car dyno'd as I was curious about the A/F, etc after Ford replaced the PCM and retuned....

 

 

here are the new numbers...

 

STD 478.89 Max torq 437.18

SAE 466.76 Max torq 426.10

 

A/F -flatline at 12 from 3500RPMS to 6200RPMS

 

93 octane tune

 

Previously at QP with temps over 105 and humidity it was 437 at the rear wheels and they told me then that it was more likely to be closer to 470 w/ better temps and lower humidity. Not sure about all that, but I was pleased with the numbers so now I can just drive it and enjoy...... :happy feet: :shift:

Link to comment
Share on other sites

Nice numbers, congrats and enjoy!

 

As tempting as it is toi grab at higher numbers, stick with the SAE corrected numbers. STD numbers will always be a tad higher, but you can rest easy that the SAE numbers are more reliable and can be replicated at will.

 

Hope to see ya out there someday.

Link to comment
Share on other sites

Nice numbers, congrats and enjoy!

 

As tempting as it is toi grab at higher numbers, stick with the SAE corrected numbers. STD numbers will always be a tad higher, but you can rest easy that the SAE numbers are more reliable and can be replicated at will.

 

Hope to see ya out there someday.

Agreed 110% - STD #'s will vary wildly depending on conditions. SAE is the only way to go.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...
...