clawsonbob Posted August 8, 2007 Report Share Posted August 8, 2007 My rear bumber cover is very loose at bottom edge ...appears there is/was a plastic tab there that should have supported bottom edge better. anyone else with this issue or oics of plastic tab in place ? my bumber cover feels about ready to flop off at highway speed thanks bob Link to comment Share on other sites More sharing options...
stump_breaker Posted August 8, 2007 Report Share Posted August 8, 2007 My rear bumber cover is very loose at bottom edge ...appears there is/was a plastic tab there that should have supported bottom edge better. anyone else with this issue or oics of plastic tab in place ? my bumber cover feels about ready to flop off at highway speed thanks bob If I remember correctly, there are three tabs, one on each side and one in the middle and they are held to the car with a plastic retainer. When I was playing with the exhaust, I noticed my middle one was a little loose but not enough to make a difference. If you're missing that middle tab, it could cause you a big problem as that is the only support I could find for the bumper cover. Link to comment Share on other sites More sharing options...
stg Posted August 10, 2007 Report Share Posted August 10, 2007 My rear bumber cover is very loose at bottom edge ...appears there is/was a plastic tab there that should have supported bottom edge better. anyone else with this issue or oics of plastic tab in place ? my bumber cover feels about ready to flop off at highway speed thanks bob Look under the rear bumper ,, center tab remove it ,go back just a hair towards the front of the car ,drill a pilot hole SMALL !!! then pull the bumper towards the front of the car, use a small sheet met. screw, I have had no more problems ,also I had to take off the metal tag frame REAR and replace it with plastic good luck Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.